12v led monochrome and rgb ribbon installation.
Calculate the length you want to enlighten to know the stretch of LED strips that we need.
In cases where you must cut a section, the tape must be cut every 3 LEDs with scissors here or signposted.
You must clean the surface where you are going to stick the Ribbon. Then remove the protection of the posterior adhesive strip and glue the Ribbon to the desired area.
Step 4 (optional)
Connect it to the controller in case you want to use this device to control the light intensity. There are different types of controllers or dimmers, depending on if there are remote control or not. See the Drivers or controllers for LED strips
Now connect the Ribbon with the power supply. For this connect the wires to the red and black ribbon to the power supply as follows:
SIGN + or + V with the Red wire
SIGN – or – V with black wire
Connect the power supply to 220VAC (Phase, neutral and ground) sector. The installation is complete. See blocks/Sources of power supplies
Installation of the ribbons 12V LED with amplifiers
When our lighting project exceeds 8 metres long, we will have to use amplifiers to ensure a consistent and uniform light intensity throughout the system.
In the installation plan, we see how to apply the amplifiers.
Join two sections of 12V LED strips
Cut the Ribbon all 3 LEDs with scissors where indicated.
Join the sections: If your Ribbon is RGB (4-wire) or monochrome (2-wire), you will have two types of connectors: rigid connectors or cables connectors. And you can get more from GRADPHYSICS.
These are safer and more resistant joints. You can attach both ribbons to make a straight line, a right angle or by assembling two more ribbons form in “T” or “X”.
Cables connectors (Union flexible cable)
The joints are less robust, but more likely to give other posibilities to join the sections. Check all connectors for RGB LED or connectors for ribbons LED Monochrome ribbons
Remove the adhesive cover and paste sections into the area to be lit. Be sure to clean the surface beforehand.
Connect the Ribbon to the controller in case you want to use this device to control the light intensity. There are different types of controllers or dimmers, depending on if there are remote control or not. . Check them out Drivers or controllers for LED strips for
Connect the power supply to the controller. The source must provide both the total power required for the controller. See blocks/Sources of power supplies
Christmas By The River Photos and Images
14W Bare Board White & Warm White Light LED 5630 SMD Rope …
12W Bare Board White Light LED 2835 SMD Rope Light, 120 …
1M USB SMD5050 LED White/Warm White RGB Waterproof Strip …
12V Ultra Thin LED White Under Cabinet Panel Light (AQUC …
ST10 10mm Silicone Tubing
Gallery of W London Leicester Square / Jestico + Whiles
Flat Power Cable – 2 Conductor
Ford F-150 Lightning LED Bulbs Installation
Angle Adjustable Mounting Clips for most LED Strip Light …
2C White LED 22AWG Power Wire
Shop Northlight Pre-Lit Frankenstein Novelty Light with …
E831-R recessed deep aluminium profile
Deck with Rail Lighting – Traditional – Porch
Roland DJ-808 4-Channel Mixer & DJ Controller with M-Audio …
RCF EVOX 12 Active Portable 2-Way Array PA System …
How Many Lights for Trees?
12W Bare Board Warm White Light LED 3014 SMD Rope Light …